Huffy Recalls Buzz Cerana T2 E-Trikes Over Rear Wheel Detachment

Huffy has recalled about 286 Buzz Bicycles Cerana T2 pedal-assist electric tricycles (Model E4004) after 12 reports of rear wheels loosening or separating from the frame, including three rider injuries. If you own one, stop riding it immediately and request a free replacement rear axle assembly plus up to $100 toward shop installation.

The recall (CPSC Recall No. 27-086), announced November 12, 2026, affects gray three-wheeled e-trikes sold nationwide at independent bike shops and online at Buzz Bicycles from November 2024 through July 2026 for $1,400 to $2,500.

Which Buzz Cerana T2 E-Trikes Are Recalled

Side view of the gray Buzz Bicycles Cerana T2 pedal-assist electric tricycle
Check the label on the underside of the downtube near the pedals for model number E4004.

Only one model is covered by this recall. You can verify yours in under a minute by checking the frame sticker near the bottom bracket before your next ride.

Recall DetailAffected Specification
Model Name & NumberBuzz Bicycles Cerana T2 E-Trike — Model E4004
Recall Number & DateCPSC Recall No. 27-086 (November 12, 2026)
Units AffectedAbout 286 in the United States
Frame & HardwareGray frame with “BUZZ” logos on both sides, 500W motor, 48V battery, three 24-inch wheels
Where & When SoldIndependent bike shops and buzzbicycles.com (November 2024 – July 2026, $1,400 – $2,500)
Label LocationUnderside of the frame’s downtube near the pedals

Huffy reported 12 incidents where the rear wheels worked loose or detached completely from the rear frame. Three riders suffered shoulder and wrist sprains, leg bruising, and abrasions as a result.

Why Rear Wheel Separation Is Especially Dangerous on an E-Trike

Three-wheeled electric trikes handle cornering forces differently than two-wheel bicycles. Because a trike stays upright without leaning into turns, every sharp corner, driveway apron, or uneven curb pushes lateral load directly into the rear axle shafts and wheel hubs.

Add a 500-watt motor, a 48-volt battery, and groceries in the rear basket, and the rear axle carries far more weight and twisting force than a standard pedal bike. If one rear wheel loosens or separates at 10 to 15 mph, the rear frame drops onto the pavement and pivots abruptly, leaving the rider almost no time to catch a fall.

That is why tightening a loose axle bolt at home is not a safe workaround. Even if a wheel feels snug in your driveway, road vibration and turning loads can back it out again within a few miles.

How to Get Your Free Axle Kit and $100 Repair Credit

Bike mechanic inspecting and servicing an electric bike rear wheel assembly
Huffy will ship the replacement rear axle assembly to your home or directly to a local bike shop.

Huffy is providing two parts to the remedy: a free replacement rear axle assembly and up to $100 in reimbursement if you pay a third-party bike shop to install it.

  1. Park the trike now: Keep the Cerana T2 off the road and out of service until the new rear axle assembly is installed.
  2. Photograph the model label: Flip a phone camera under the downtube near the pedals and snap a clear photo of the E4004 sticker plus your frame serial number.
  3. Contact Huffy: Submit your claim on the Buzz Bicycles recalls page, email service@huffy.com, or call 855-430-6240 (Monday through Friday, 8 a.m. to 5 p.m. ET).
  4. Choose home or shop delivery: Ask Huffy to mail the free replacement rear axle assembly directly to your address or straight to a local third-party repair shop.
  5. Keep your itemized shop receipt: Once a mechanic completes the swap, submit the paid invoice to Huffy for up to $100 in third-party labor reimbursement.

Because rear differential and dual-wheel axle assemblies on heavy e-trikes require proper torque and alignment, I would let a local shop handle the swap and use the $100 reimbursement rather than guessing in a garage. Before you drop off the trike, call the shop to confirm they service heavy electric trikes—some small neighborhood shops lack wide enough repair stands or floor space for three-wheeled frames.

How to Make Sure the $100 Reimbursement Goes Smoothly

Bike shop labor rates vary widely across the United States, and a rear axle rebuild on a heavy e-trike can take 45 to 90 minutes depending on whether brake rotors or chain guards need adjustment. Asking a few quick questions upfront prevents surprise out-of-pocket charges.

  • Confirm the labor estimate before work starts: Ask the service writer whether the swap stays under $100, and keep in mind you will cover any labor above Huffy’s $100 cap.
  • Request an itemized invoice: Make sure the receipt lists your trike’s model (Buzz Cerana T2 / E4004), the date, and a clear line item for the recall rear axle installation.
  • Ask for a quick rear-end safety check: While the rear wheels are off, have the mechanic check rear brake pad alignment, wheel true, and spoke tension at the same time.
  • Do not ride the trike to the shop: Transport it in a truck bed, cargo van, or hitch-mounted trike rack rather than riding an affected unit on public streets.

What This Recall Means for E-Trike Shoppers

Wheel-attachment recalls have shown up across several bike categories in 2026. Earlier this year, the CPSC warned riders off certain Ridstar Q20 models over front-wheel detachment risks and tracked rear-wheel bolt recalls on select Trek and Electra e-bikes equipped with Hyena hub hardware.

If you are shopping for a three-wheeler right now—or comparing alternatives while waiting on replacement parts—pay close attention to rear axle construction and dealer support. Look for brands that publish clear torque specs, use UL 2849-certified electrical systems, and maintain an active parts desk if an axle or bearing wears out years later.

You can compare current three-wheel options in our best three-wheel electric bike guide, or check our 2026 e-bike pricing breakdown to see what separates $1,400 budget models from $2,500+ shop-supported builds. If you also want to know how warranty coverage holds up when a brand restructures or stops selling a model, read our guide on what happens to your e-bike warranty when a brand goes bankrupt.

Frequently Asked Questions

Where do I find the E4004 model number on a Buzz Cerana T2?

Look under the lower frame tube right near the pedal crankset. Huffy prints the E4004 model number on a sticker on the bottom side of the downtube.

Do I need my original store receipt to get the free replacement axle?

No. Under CPSC safety recalls, you do not need the original proof of purchase to receive the remedy. Having a photo of the E4004 label and frame serial number is enough to start a claim with Huffy.

What if I bought my Buzz Cerana T2 secondhand?

Secondhand owners are still covered by the recall. Stop riding the trike, confirm the E4004 model sticker under the downtube, and contact Huffy at 855-430-6240 or service@huffy.com to request the replacement axle kit.

Are other Buzz e-trikes or two-wheel Buzz e-bikes included in this recall?

No. CPSC Recall No. 27-086 applies only to the gray Buzz Bicycles Cerana T2 pedal-assist e-trike marked Model E4004 sold between November 2024 and July 2026.

Does Huffy cover the full cost of having a bike shop install the new rear axle?

Huffy provides the replacement rear axle assembly free of charge and reimburses up to $100 for third-party shop repair fees. Call 855-430-6240 or check with Huffy before booking service so your itemized receipt qualifies.

Bicycling Land Editors
Bicycling Land Editorshttps://bicyclingland.com/about/
The Bicycling Land editors research bikes, e-bikes and cycling gear for US riders. Recommendations are built on manufacturer specifications, independent reviews, owner reports and safety records, with every claim linked to its source. Read how we work on our editorial policy page.

Popular Guides

Related Articles